Electronic control unit with Micro-process and permanent memory. N.2 heating programs: one program for TRADITIONAL coatings, who contains up to 3 phases (with choice of Temperature, Temperature increase rate expressed in °C per minute and holding time) and one program specifically studied for FAST coatings. Ignition delay up to 100 hours. It comes in 3 different versions depending on the size: S, M, and L. All versions can be equipped with flue fume aspiration (SR731). Fire Light 720 S - chamber cm 16x16x10 Fire Light 720 M - chamber cm 18x23x11,5 Fire Light 720 L - chamber cm 23x30x15   Technical...

PERFORMANCE AND USEThe oven, as previously said, can memorize up to 20 pre-heating cycles (or programs) (15 normal programs with 6 phases + 5 fast programs with 1 phase) which are kept in the memory until the operator decides to modify them. Each program contains 6 phases and for each phase it is possible to set 3 variables: temperature, increase rate, holding time. It is also possible to set an Ignition delay and the fumes aspiration fan Off temperature (fume chimney). Furthermore it is possible to set a final temperature holding time at the end of the cycle: this is to keep the cylinders at...

The SR 852 “Luxor Ceramic” is the last generation furnace for firing ceramics, it is managed by an electronic control designed to extremely simplify and ease up the technician’s work in ali the working cycle phases.   Here are the main innovations introduced by the electronic control: a very powerfui 16 bit microprocessor; a frontal Encoder for the input and research of both data and functions; a “Flash” type memory which can be re-set and updated by the operator through Internet (this allows the possibility to update at any time the furnace with the last software...

The SR 862 "Luxor Press" is a fornace suitable for ceramics obtained through "Press-injection" after having heated the solid ceramic up to its plastic status. The ceramic injection process is done through a mechanism operated by compressed air. The injection pressure can be regulated with a manual pressure regulator, supplied with a manometer for the visualisation. The fornace must be therefore connected to the air compressed system of the laboratory or a compressor. In the firing cycle all variables related to Press-injection can be set, the fornace is therefore suitable to fire all types of...